How to put together a tattoo gun

What voltage should a tattoo shader run at?

When doing line work, best practices indication you run your machine at 7.5-8.5 Volts. When shading 8-10 Volts is what maximum artists use.

How deep should a tattoo needle go?

between 1mm and 2mm

Why is my tattoo gun not working?

At this time, the needle and the armature bar will be fixed tightly if the rubber band is too tight. and the armature bar will not move. The machine will not work. So you need to check the power supply, the clip cord, the contact screw, the armature bar, and the rubber bands before tattooing.

Where do the rubber bands go on a tattoo gun?

The rubber band must not be twisted, but straight, going around the machine rear, the coils and the needle bar, easily and secure.

1 year ago

Leave a Reply

Your email address will not be published. Required fields are marked *